MPC 67 Charger

[Johnt671]

I started this one a couple of days ago. It is the second of three Charger generations I'm going to do. All three with be the same color scheme and be Hemi powered. the third picture shows the slightly raised rear end .

Edited March 15, 2020 by Johnt671

[espo]

This should be fun to follow. I like the stance so far. Are they all going to be silver then ? 

[Luc Janssens]

Too bad these all suffer from sinkmarks at the front and rear cap, one would think engineers would've solved this problem by altering the tooling a bit in those areas.

[Johnt671]

3 hours ago, espo said:

This should be fun to follow. I like the stance so far. Are they all going to be silver then ? 

Same color with a flat black hood on all three.

[Johnt671]

3 hours ago, Luc Janssens said:

Too bad these all suffer from sinkmarks at the front and rear cap, one would think engineers would've solved this problem by altering the tooling a bit in those areas.

it is a pretty basic kit. I was going to wire the Hemi. but I decided to save my pre-wired dizzy's for another day.

I'm warping the rear end to hide the way I raised the rear end.

[Johnt671]

I found a set of resin Cragar wheels that look good, and the 66 meets it's brother from another mother for the first time.

[Johnt671]

Progress over the last few days.

[Johnt671]

Some progress. I cleaned my Molotow tips and got the nice chrome look back, and did the decals on it.

[Johnt671]

Close to finish now.

[Johnt671]

This one is done. Later I'll post more finished pictures in the Under Glass section for those who are interested.

[72 Charger]

Nice work you need a 3rd Gen Charger now to complete the set

[Johnt671]

2 hours ago, 72 Charger said:

Nice work you need a 3rd Gen Charger now to complete the set

I'll have to look around for one, thanks.