Model Master Custom Lacquer System Question

[Modelbuilder Mark]

I have a large supply of MM Lacquer system, and I have a question. I have noticed that some of them SAY 2 part (basecoat/clearcoat) on the side of the can, while others doe not yet they share the same paint#. Are ANY of those that say Custom Lacquer System 2 part? I have a bunch that I have bought over time, but not used. 

[StevenGuthmiller]

It’s my understanding that the “Custom Lacquer System” was always intended to be a base coat/clear coat system.

Now of course a “fabric” color, while within the same system, wouldn’t be clear coated for obvious reasons.

 

 

 

Steve

[64SS350]

My advice is to try and use them up, and at minimum....store in a container of some sort. I have had several eat through the can seams and leak.....some profusely if not detected in time. 

[kensar]

One interpretation of the label could be that the base color and clear coat are combined in the same can and no additional clear coat is needed.

[Mike 1017]

I used Fabric Tan and Fabric Gray, but I just spayed them over gray or white primer. They also had a 2-part white vinyl roof system that I used with great results. I still have about a 1/2 can of tan left.

Mike

[Modelbuilder Mark]

11 hours ago, 64SS350 said:

My advice is to try and use them up, and at minimum....store in a container of some sort. I have had several eat through the can seams and leak.....some profusely if not detected in time. 

I have some leakers as well, LOL. I bought a lot of paint from Hobby Lobby when they were clearing them out, and any time I found a good deal. I have a lot of paint, probably too much. 

Thanks to everyone else for your input.