Jump to content
Model Cars Magazine Forum

Recommended Posts

Posted (edited)

this a 3d resin printed model i printed of porkchop's 3rd racing vehicle in the hot wheels acceleracers movies
it is either 1/42 scale or 1/35 scale as 1/48 scale figures are to small and 1/32 scale figures are to big the total length of the model is 5 inches long
i painted the body a base coat of rust-oleum bright coat aluminum and a top coat of east up high performance wheel paint molybdenum red
i masked off the engine the cockpit and roll bars and exhaust tips and the lower raised detail on both sides of the car with blue painters tap before i painted the top coat
i printed the rally lights and rims and tires and steering wheel seperatly
i did the grille surround and the tail light housings and the upper raised side details with a silver sharpie and used a black sharpie for the grille and body graphics

 

Edited by michelle
  • Like 4
  • michelle changed the title to piledriver (acceleracers)
Posted (edited)

here are some of the specs on this car from the  acceleracers movies 

430 HP

90 Degree Twin Turbo Fuel Injected V8

Custom 7-speed transmission

Headers

Impact resistant thermoform polyurethane body

Wide Fenders

Chromeoly tube chassis

Pushrod suspension

intercooler tubes

Quad-pipe exhaust system

Roll cage

Anchor chain

Dragon Torch

Vacuum effect

1 seat

Forward ramming blade

5000 candlepower night lights

Nitrox 3 1/2

E.D.R.  aka emergency driver return  which is a device which allows drivers to return to the acceledrome while in a racing realm without their vehicle 

Top speed: 277 mph

Edited by michelle
Posted
2 hours ago, karbuildr said:

That is very nicely done Michelle. I like the colors and styling of this vehicle.

thank you 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...