Jump to content
Model Cars Magazine Forum

Recommended Posts

Posted

I just purchased a Moebius 1955 Chrysler 300. I plan on superdetailing the kit, and the engine as well. Could you tell me where the ignition wires go after being installed from the distributor cap?

Thanks.

Posted

The go in through the valve covers like all Mopar Hemis, but the Moebius kit has the plug wire covers molded to the valve covers. I'd cut a small hole just behind the rear of this cover (it is the rectangular piece with three simulated screws) and insert the wires off the distributor into that.

Posted

I did just like Chuck said to my '57 Chrysler 300C project, and here's one shot where you can see, where I drilled those holes.

P1190227.jpg

Hope This Helps. ;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...