'71-76 Delta 88?

[Chuck Most]

I've been hunting around for one of these- I'd planned on converting an MPC Caprice into one, but I'm not feeling up for it. Am I missing any sources?

[lizardlust]

R&R Resin has a repop of the Juha Airio mastered 71 Olds Delta 88 2-door hardtop.

[Chuck Most]

I was afraid the R&R piece was the only shot (short of finding an old AAM casting). Might have to go that route.

[peter31a]

R&R should be all right for what you're doing cuz once you put that steam engine on it nobody will notice any imperfections. What? This isn't for the same project?

[montelsc]

This is the R&R kit its not bad

[gray07]

That is pretty cool.

[Edsel-Dan]

I like that one.

If Juha Airio mastered it, I would Not expect some one to call it only

passable like most of their other castings

But, I have no idea what they may have done to the master before casting

[Chuck Most]

True, Dan- but in this case it isn't the quality of the master I'm worried about, its molding quality. The last few R&R Delta 88's I've seen in person had quite a bit of core-shift evident in the casings, in addtion to rough plating. R&R is notorious for running their molds right into the ground.