Anybody want a Liberty Transmission?
Posted 27 June 2012 - 08:00 AM
Here are some photos.
Posted 27 June 2012 - 10:30 AM
Posted 27 June 2012 - 12:06 PM
Bonekrosha, You may want to be a bit more specific as to what you consider through the roof for price... Because what you consider may be lower than what I would consider high/expensive.
Since these parts are 3D printed they are going to be a bit more expensive.
How about that Liberty shifter that is what I would like to get a hold of!
Edited by eviltwincustoms, 27 June 2012 - 12:08 PM.
Posted 27 June 2012 - 12:31 PM
That shifter would be awesome. Maybe one of the photoetch guys could make this and we could add the arms. Here are some detailed photos.
Posted 28 June 2012 - 02:07 AM
True...... it costs a little more than the less expensive material but the time saved in sanding is well worth the cost difference.
I ordinarily use the cheaper printed parts (only) for things like engine blocks etc. where I want the sand cast finish to show.
Parts that are supposed to have a "smooth, polished" finish, F.U.D. is the way to go....you don't wind up knocking all that wonderful detail off by sanding and save yourself a bunch of finishing time.
As far as the cost goes....it is what it is, as you've said the price is controlled by the type and amount of material used in the printing process.
Edited by GrandpaMcGurk, 29 June 2012 - 03:08 AM.
Posted 28 June 2012 - 10:44 AM
Posted 28 June 2012 - 01:35 PM
Having the shifter & linkage would definately be awesome, I'd almost rather buy that and scratch myself out a tranny
Posted 28 June 2012 - 04:10 PM
Posted 29 June 2012 - 04:57 AM
Is there a web site I can upload files to, so that others can download them? Otherwise PM me with your email address and I'll send what I have.
Paul Evoy is getting some info this tranny. Does anybody else have access to a real one for measurements?
Posted 08 July 2012 - 12:50 PM
Posted 07 August 2012 - 12:57 PM
Posted 21 November 2012 - 11:45 AM
I was finally able to get dimensions off a 5-speed and am going to start working on both the trans and PE shifter.
Posted 21 November 2012 - 12:38 PM
Posted 24 November 2012 - 02:15 AM
I've emailed TDR to see if they might change their minds, but if Scott is working on one, we should go with that.
Posted 24 November 2012 - 10:31 AM
I may have to wait for TDR to catch up though, as I will most likely need a 1/12 version....