Jump to content


Bruce Poage

Member Since 31 Mar 2006
Offline Last Active Apr 22 2014 03:22 PM
-----

Posts I've Made

In Topic: Masking Tape Residue Problem/Questioin

22 December 2013 - 10:41 AM

I've been at this hobby for a long time--started when I was 12 and will soon see 70!!  But I can always learn something new.  Thanks guys.


In Topic: A Bit of Philosophy

12 November 2013 - 12:15 PM

Awesome to hear from the guy who penned this work.


In Topic: Warming spraycans in dehyddrator

28 October 2013 - 10:52 AM

Been modelling for many decades.  Warmed spray cans in warm water sink or container during 5th decade. Switched to dehydrator in current decade.  I have a low budget dehyde.  I leave the top off and have monitored highest temp to be 103-105.  I usually think 30 min to be long enough but as I am near 70 and occasionally have a memory wrinkle have I have left a can or two in l-o-n-g-e-r than that.


In Topic: Never give a farmer a welder.....

15 October 2013 - 04:28 AM

Absolutely awesome.  It would only be better if spotted in front of a luxury import dealership!!


In Topic: Krylon Problem/Question

02 September 2013 - 02:38 PM

Thanks for all the great info.Toluene is listed on the label so I was assuming this was a lacquer.  As with other lacquers I was allowing 15-30 minutes between coats going from color to clear with the same timing.  I am thinking I can continue to apply color in this increments but then allow several days before clear or do I run all color and clear and then in the cooker for several days.  Appreciate the guidance and direction.