Murphy's Law Posted October 27, 2009 Share Posted October 27, 2009 I bought one of the PediPaws for my two dogs. Unfortunately, they can't stand it. However, all hope was not lost. I found it to be a very useful for rough sanding (burrs and such). It has a low enough speed that it is very easy control and I would suppose be safe for kids. I got it at Walgreens for under $20. Quote Link to comment Share on other sites More sharing options...
cruz Posted October 28, 2009 Share Posted October 28, 2009 I bought one of the PediPaws for my two dogs. Unfortunately, they can't stand it. However, all hope was not lost. I found it to be a very useful for rough sanding (burrs and such). It has a low enough speed that it is very easy control and I would suppose be safe for kids. I got it at Walgreens for under $20.Hey Chris, same here, my dogs can't stand it either, only I am not going to say "unfortunately" like you said, this thing will be part of my modeling tool arsenal!!! My wife bought this thing about 6 months ago and it didn't cross my mind to use it for modeling, thanks for the idea!! Quote Link to comment Share on other sites More sharing options...
crazyjim Posted October 28, 2009 Share Posted October 28, 2009 I bought a Wahl battery sander a few years ago and then bought their electric sander. Both work great and have different grits of paper that can be attached as well as some files. Quote Link to comment Share on other sites More sharing options...
David G. Posted October 30, 2009 Share Posted October 30, 2009 I have a Braun Oral B battery-powered toothbrush that I sand with. It's easy to pull the bristles out of the used replacement heads and use some RTV silicon to glue little hand-cut discs of sandpaper to them. The RTV dries adequately in about five minutes, and I can set up several grits ahead of time. That way, I just swap the heads when I'm ready to go from using 400 grit to 600, etc. Quote Link to comment Share on other sites More sharing options...
James Flowers Posted October 31, 2009 Share Posted October 31, 2009 Our dog does not like ether. That sounds like a good idea to use as a sanding tool. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.