AlbertS

Thx for responding. I am looking forward to his "recommissioning AITM", it would be nice to purchase what I should have and did not get around to-back then. It would be a blessing to get a second chance at these fine products.

Just wondering where the "reboot" of AITM stands? Looking to make some purchases, hope you are on track, but it is what it is, please advise. Thx

I agree! You were making your way through 72, no do the 73-79 cab and the 80-86 cab, I asure you, you have a buyer here if you do.

Dave has a 56 Ford F800 Big Job Cab for sale. Looking forward to ordering this from you when you open.

Thx. This model truck is what I learned to drive in-a 62 C20 with the 4speed, roll up windows manual steering brakes manual yada yada yada-none of the stuff that is normal now but luxury back then. I am going to be building one of these, and am planning on the 8-foot bed, whenever someone picks up where others left off at and has for sale, and I can make the purchase. Nice job again on project!

Nice job! Where did you get the rear tires?

I agree. Too many times now, I was waiting to purchase, and then the vendor closed or went away. (Still hoping Rookie Resin reboots, really wanting two sets of those 8' 1962-1966 Chevy Pickup sides.)

If you would, thank you

Thx for the reply's. I hadn't been on the board in a while and never got any notice of responses. Just wanted to again say thanks and not appear rude. Still working towards the gears and chains, even looked into the gears on RC axles, but the chain part is not to scale.

Thanks for the reply. I have looked and not been able to find any. Might u have any aftermarket names to direct me to for these?

I am working on a large-sized dump body insert salt spreader and am looking for gears and chains to drive the auger and spinners. Just wondering if you have any ideas on sources. Thank you for your response. AB

a site called trailer trash used to have the Ford 7.3L & the GM 6.6L Duramax, I did not check them recently, but am suggesting here for you to see if they still do.

Which Indy kits are you speaking of? Some type of race car with a tow perhaps?

I will check it out, thx.

I am working on an stand-alone salt spreader that slides into the back of a 10-ton dump body. Am looking for suggestions on an air-cooled engine I could use, 1/24 or 1/25, if anyone has any ideas. Thx in advance for your input.