lanesteele240

Thanks teddey. I will try it but there is a limit to how small the radious is on the bender. I saw some other dude on another forum use milliput. So i cut off a sharpy on both ends and extruded some after packing it in. Here is the result. After it cures i will sand file and prime it. If it looks good i will go with it

Next up is making the intake tubes This was a fail fail fail event I started with 5/32 aluminum tube and a tube bender. It did not go well Fail More fail Close but u can see it is mashed on the inside in person I then had an idea to temper the tube More fail as i tempered it toooooo much And finnally a win or two

I built a intake plenum. All i had was a few vauge pics to make it from.

Pipes and i added the rear roll bars

Ill just pile on one more wow Wow!!!!!!

Ahhhh. Here you are ken. I found your build. Good to see i will be learning something again. Cant wait to see more

Stoppers. I just glued the outside to the rotor. I have been down the full pe rotor road. It leads to wheels popping off out of thin air and u dont even ser it if you put the wheels on

Sorry for the break but i had to spend some time with the wife I fixed The hatch with some flat stock I cut out the hood ducks?(? that is as close as i can get to a duck. ) I added the vent parts and It looked good till i sprayed some primer on it. I knew the ca filler would need some more attention though Thanks for looking Untill later

Looks cooler up anyways

This a great looking kit. When i clear a few kits out the stash, i will be picking one up

I like this kit But i just cant understand why trolls have to bring "this vehicle has a terrible what ever and is not as good as my brand". If you dont like it, dont buy it or even comment. Please dont let my post spiral into a forum fight. I will buy one just to have a change in the stash. Looking forward to seeing some built also. Just as the mobieous truck

I like the way you never ever ever use a part for what it suposed to be used for

I do want this kit. Just cant figure out if i want the revel or the tamiya. Ill make my choice watching you build And you are off to a great start And you are off to a great start

Its is a cool project

Dashboard and comtrols It is starting to take shape This is how i figured best to add the belts to the metal parts.

The gold on black rims is hot. Great lookin model

I dig it. Flawless paint

Very clean as usual

Here is the edward printed seatbelts They were a hoot to put together If you ever get a set of these, put the belt part on the buckle part and then cut the buckle off the spure I cut the rear hatch off and had one of those, what have i got myself into moments.

Dr plastic. You must post in the correct area. We have a question and tip section below. This one is for works in progress Your answer One would be a good oven cleaner Or bleach Or break fluid

That looks cool

Looks great. I have the revel kit 1/3 started and put back in the box. This is the kind of spark i need to get back on it

Looks very clean on a kit that has a ton of challenges to get over. The blue is awesome. Is it scale finishes.

Looks awesome. Way better than the run of the mill general

This is what im shooting for