Looking for small scale triangular rod (1:1 size = 1/2 inch).

[Monty]

Didn't see anything like this on the Evergreen or Plastruct sites.  Any other sources out there? 

[SfanGoch]

Obviously, you didn't look past the first two or three pages:

styrene-strip-stock-rod

Edited May 28, 2019 by SfanGoch

[Straightliner59]

4 hours ago, SfanGoch said:

Obviously, you didn't look past the first two or three pages:

styrene-strip-stock-rod

Link is broken. Plastruct or Evergreen?

[SfanGoch]

The link will work now. I didn't enter the complete URL. BTW, it's Plastruct.

Plastruct offers triangular styrene rod from .030" - .125".

Edited May 28, 2019 by SfanGoch

[Straightliner59]

Well, dang! OP was looking for .020". I thought maybe you'd found some! I know I have at least their .030" and .040"triangular rod. Thanks, Joe!

[Flat32]

No mention of how much is needed or final length of the part but theoretically it might be possible to heat and stretch the material.  I'm considering giving it a try to slim down some Plastruct hex rod for scale 1/2" hex bolts and nuts. Figure to hang the rod vertical with some weight at the end and pass my mini heat gun nozzle along the length.

[Monty]

10 minutes ago, Flat32 said:

No mention of how much is needed or final length of the part but theoretically it might be possible to heat and stretch the material.  I'm considering giving it a try to slim down some Plastruct hex rod for scale 1/2" hex bolts and nuts. Figure to hang the rod vertical with some weight at the end and pass my mini heat gun nozzle along the length.

I'd vastly prefer .020, but if .030 is the closest I can get, I'll try and make it work.  Thanks everybody.