Proper hood for the '69 1/2 roadrunner

[5150ratrodder]

Does anybody know if there was ever a proper Hood for the a-12 6 bbl option? If not a copy of the super bee 6 pack version?

[1972coronet]

Hart's Parts Resins . I've bought items from Hart , and they are top notch --- "buy with confidence"

 https://hartspartsresin.com/product/69-plymouth-rr-gtx-6pack-hood/

 

[5150ratrodder]

Thank you. Is it the Plymouth flat hood or the dodge(raised center)version?

[1972coronet]

41 minutes ago, 5150ratrodder said:

Thank you. Is it the Plymouth flat hood or the dodge(raised center)version?

"Upon further review..."   It would appear that the piece I'd recommended is a Satellite bonnet with a 6Bbl. scoop ! My apologies . I don't have any other recommendations at this point .

[drodg]

13 hours ago, 1972coronet said:

"Upon further review..."   It would appear that the piece I'd recommended is a Satellite bonnet with a 6Bbl. scoop ! My apologies . I don't have any other recommendations at this point .

I think the RoadRunner 691/2  had the bulge like it was from a Satellite...    

[gtx6970]

Hood for an A12 roadrunner has a pretty distinct bulge in the center forward of the scoop . Its not flat by any means

 

And the best version Ive found so far is the one is/was made by Wendal Sowers in Tenn. But Ive not seen one listed in a while so odds are its no longer avail. I bought about a half dozen of them when He made them

 

I had  one of the Harts parts duster six pack hood,,,and any here can have it, I refuse to use it . I hope his roadrunner is better

[5150ratrodder]

I guess me eyes must have deceived me. I apologize for not researching further.

[Brutalform]

I’ve bought and used the Harts Parts hood, and had good results. Minimal cleanup around the scoop openings, and an overall nice fit. 
He also sells the bench seat for the 69 RR as well. 

Edited February 25, 2020 by Brutalform

[440 Dakota]

Thanks for the pics I've been wanting to build a kit of a 1/1 that I owned in the 90s and this thread had me second guessing the raised part, that I remembered cause I've seen plenty of generic flat ones as well

[Brutalform]

Pretty much the same question I had when building mine. Gene (Geno),helped me with my question with a good pic of the actual car with the bulge in the hood. 
 

 

Edited February 25, 2020 by Brutalform