Checking to see if there is a 3d printed transkit to turn 1/16 MPC '79 Trans Am into a '70 Trans Am

[blunc]

Possibly anyone that has 3d modeled the front and rear facia and bumper assemblies for a 1/16 scale MPC '79 Trans Am.

[SSNJim]

I don't know, but the transkit will need a new body and rear window. The rear window changed in 1975 from a regular rear window to a wraparound one, so they're quite different between a 70 and 79.

[blunc]

I think most of the body is close enough to rework, the rear window would most likely be easier to fix than the work required to create the front and rear bumper and facias, I guess this will remain on my far back burner.

 

[SSNJim]

Agreed. It wouldn't be difficult to fix the rear window if you're comfortable with bodywork; a lot of people aren't. Even the rear end wouldn't be too bad to construct, but the front would be much harder. Good luck, and I hope you find it. Sounds like an interesting model.

[DPNM]

I'd be interested in the nose pieces needed to turn the 79 into a 77/78 if there is a source for that.