Need help

[JerseeJerry55]

Good day all,

Hope everyone's well. In the process of starting my second AMT Transtar CO4070A and after painting the interior bucket I noticed the following. It appears that the left side rail where the hinge pins are may be slightly "crooked". If anyone has built this kit can you please advise if this looks correct, or is indeed a little off. If I need to redo the rails what is the best course of action, freezer and then carefully separate and then redo it? I have included pics of both rails for comparison. Thank you and have a great day.

Kind regards,

JerseeJerry55

[NOBLNG]

 Not familiar with this kit, but what type of glue did you use?

Edited yesterday at 11:43 AM by NOBLNG

[JerseeJerry55]

21 minutes ago, NOBLNG said:

 Ot familiar with this kit, but what type of glue did you use?

Styrene Mr, Hobby

[NOBLNG]

I can’t tell you if it needs to be corrected, but if that “Mr. Hobby” glue is a solvent like Tamiya Extra Thin, then the only way to break the joint if it is completely dried, is to cut it apart. I would suggest a photo etch razor saw. Drill and pin the parts before re-assembly at the proper orientation.🤷‍♂️

[Muncie]

Might try checking fit and alignment with other parts - I'm not familiar with this one but some cabovers have differences between lefts and rights.