Jump to content
Model Cars Magazine Forum

Recommended Posts

Posted

I just finished my 70 1/2 Split Bumper It started life as the AMT Baldwin Camaro but once I started it became clear that it had loads of issues. First the chassis was warped pretty bad then the roof line had an indention of the dome light so I figured that I would chop it up and make a strip/street  car out of it so i tubbed the rear cut the front fender wells out and built a small cage then turned my attention to the body work I used some body putty to fill the crater and after a few hours of sanding it finally looked good to me so I shot the primer and the GM factory Blue (Which came out darker than I wanted) during the drying process the hood fell and I had to strip it back to plastic and start over but I think it looks great. I ran fuel lines and made all of my own anodized fuel fittings then topped the build off with a set of aluminum wheels that I got from @vintagedragcrazy (Thanks again Vince hope I did them justice) and I named it A.A. Ron from the Key & Peele skit. Please enjoy and any comments or critiques are always welcome

 

 

20190316_154947.jpg

20190316_154926.jpg

20190316_154956.jpg

20190316_155013.jpg

Posted
On 3/22/2019 at 6:07 PM, NYLIBUD said:

Very cool Camaro.

 

On 3/22/2019 at 8:14 PM, Snake45 said:

Nice! I bet Street Outlaw Monza would like to have this for a daily driver! B)

 

On 3/23/2019 at 6:43 PM, bytownshaker said:

Very nice Camaro

 

Thanks all... Sorry for the delayed reply I have been healing from shoulder surgery and really missing the work bench :(

  • 5 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...