Bruce Poage Posted January 19, 2011 Share Posted January 19, 2011 The next kit on the bench will be the Revell '55 Ford Panel. I know very little about 1:1 engines. I would like to detail this correctly. If you are familiar with this kit can you tell me what the engine is. Thanks. Quote Link to comment Share on other sites More sharing options...
Eric Stone Posted January 19, 2011 Share Posted January 19, 2011 Got a pic? Could probably ID it for you, but I don't have the kit to look at. Quote Link to comment Share on other sites More sharing options...
Matt LeBlanc Posted January 20, 2011 Share Posted January 20, 2011 Ford 289 small block with tri power carbs Quote Link to comment Share on other sites More sharing options...
MikeMc Posted January 20, 2011 Share Posted January 20, 2011 Ford 289 small block with tri power carbs not the "stock" motor but thats what is in this kit...rear suspension is also not "stock" Quote Link to comment Share on other sites More sharing options...
Bruce Poage Posted January 20, 2011 Author Share Posted January 20, 2011 not the "stock" motor but thats what is in this kit...rear suspension is also not "stock" Quote Link to comment Share on other sites More sharing options...
Bruce Poage Posted January 20, 2011 Author Share Posted January 20, 2011 That's it. Thanks for the reply and pictures. Your rendition is looking good. Any cautions I need to have before getting in to this project. Thanks again. Quote Link to comment Share on other sites More sharing options...
MikeMc Posted January 20, 2011 Share Posted January 20, 2011 Good kit..same as the '55 pickup..different body...This was the first kit I built when I got back into modeling....painted in enamels Quote Link to comment Share on other sites More sharing options...
Chuck Most Posted January 21, 2011 Share Posted January 21, 2011 Only thing I'd watch out for on this kit (and the pickup version) is to be carful not to gunk up the hood hinge with paint or glue. Other than that, it's a pretty forgiving kit. Quote Link to comment Share on other sites More sharing options...
RickRollerLT1 Posted January 24, 2011 Share Posted January 24, 2011 The 289 engines are a little different from the Pick-Up (newer issues) and Panel van kits. The Panel van (all issues including the latest Harley Davidson release)has a Tri-Carb setup and side pipes, while the Pick-up used the same parts until the 1993 and later issues, which uses a "5.0" EFI setup with a normal dual exhaust setup, new tires and wheels, and etc. (they also have some of the left-over tri-carb parts in 'em too!). Hope this helps, V Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.