Ira

Thanks Hugh!

That's Wide Enough... Here are both front and rear Drive Units with the one inch tubing in place. More Coming...

WIDER! I decided to make the AT-AT Legs two inches wider. The Legs will fit just inside of the AT Speeder Body. I started by cutting the Leg Mounts in half. I cut some one inch lengths of plastic tubing that fit over both ends of the cuts. Then I attached the Tubing with Zap-A-Gap, CA Glue. The front unit is finished. Next I'll do the same to the rear unit. More Coming...

Looks Great so Far! Real nice work...

Speeder Underbody! I am making an Underbody for the AT Speeder with sheet plastic. I did the measuring and drew the cut lines. I cut out the Underbody with an X-acto Knife and a Steel Ruler. You just pull the Knife along the Ruler a few times then break off the excess. It's like cutting glass... Here it is glued in place. I also cut out two triangle shapes from sheet plastic. These filled the two triangular areas in the front. More Coming...

Looks Great Hugh!

Looks Great Scott! Real Nice Work...

Great Build Dale! Looks Real Nice...

Front Bulkhead Mods! I'm going to mount the Front Bulkhead Top a little lower than the Rear Bulkhead Top. So, I removed the Mounting Ridges from the Body and the back side of the Tops. Then I cut the Top Pieces as shown. I am not using the Cannon Mounting Pieces, so the Tops will lie Flat on the body. I attached the upper sections first, then I measured and cut the lower sections. After a little more fitting and sanding I glued the Pieces in place as shown. More Coming...

Hmmmm!

Great Build! Very Realistic...

Great Painting Wayne! Very Realistic...

Great Painting!

Great Progress on a Great Project! Real Nice Work Brizio...

Looks Great! Very Realistic...

Looks Great! Real Nice Build...

Looks Great! Very Realistic...

Looks Great Paul! Real Nice Paint & Detailing...

Looks Great! Real Nice Paint...

Great Build on a Tuff Kit! Real Nice Work...

Cannon Bulkheads! I'm using the tops of the Cannon Bulkheads to add detail on the sides. I'm not going to use the Cannon Mounts, so that the pieces will lay flat on the body. I glued the Flap in place and cut down the piece as shown. Here are the pieces glued down flat, in place. Both sides done... More Coming...

That is Wild Rob! Great Idea...

Looks Great John! Real Nice Work...

Great Story Mike! Thanks for sharing...

Great Build!