Jetson's Flying Car

[kruleworld]

3D printed from Thingiverse JETSONS CAR by A_SKEWED_VIEW_3D
i printed it in PLA but i cut it in half in the print software so top and bottom had no support marks (supports create texture like on the seat).
it was painted in Tamiya metallic green, with black seat and brown interior.
the clear dome is a Domino's Shake lid.
Size is about 4 inches.

on Flickr

[PappyD340]

COOL!

[robertw]

Nice almost scratch build. I got around to building the Jetson kit a couple of months ago but was lucky enough to have had one of the Polar Lights kits in my stash. It is always nice to have some of these kinds of kits around when you get bogged down on more complex projects or just need a break. A couple of companies make kits of the inventions of Leonardo da Vinci and I use them as slump busters as well. A little clean up,  a bit of improvement and a lick of paint and you've finished a project  that was satisfying, looks not bad and took less then a week of work.

[TonyK]

I like what you've done here. Hopefully you will come up with some more projects like this.

robertw has the same idea I have done in the past and the Jetsons model was one I had built.

[Mike C]

That's pretty cool. Does it fold up into a suitcase?

[slusher]

Very neat and different..

[ewetwo]

Very cool.