Revell Porsche 914-6

[Straightliner59]

6 hours ago, NOBLNG said:

The headers look great daniel.😎 I have to build a wild set for a Corvette project. I might have to look for some proper sized solder.🤔

Thanks, Greg! Also look for aluminum armature wire. It's dead-soft and works great. If I had 1/16" on hand I would have used that. I just grabbed my micrometer and started measuring what I had, on hand until I found this. It was all I had, in this size, that I could form easily.

[Straightliner59]

2 hours ago, Mark W said:

The headers look great. I like that you made the tubes equal length.

I always try to. I am generally an inch or two off, by the time everything's lined up, in place, due to trimming, etc. I couldn't find a stated length, for these, so I went with 24". Thank you, Mark!

[BK9300]

Terrific work on your headers, Daniel - lot to learn watching this.

[Straightliner59]

18 hours ago, BK9300 said:

Terrific work on your headers, Daniel - lot to learn watching this.

Thanks, Brian. I hope to get them finished, later today!