Cat D8 H reparaid

[mackd]

I was disgusted to see this tractor.Its done thyrty years ego that I have mounted,when have looked back have said how I have done to mount of this way.We have more experience.

Before reparaid

Made a new cab and install reinforcement plate.

Changed the rods for alum.

Redid the ripper in full

Drill the pads to make them more reslistic

made a sloper

Edited August 19, 2013 by mackd

[mackd]

For realistic

Détails on the motor ,tubes pum injector,trottel.hyd

Cut the hoot and quancaillery.

J have enhanced the blade that is not only slightly frequent follow up but its happened.

J attach the wear plates and J have done the welds.J am going to have to develop this tech.

[James2]

Fantastical!

How did you bend the square tubing?

[Swamp Dog]

Alain you did a great job on the Cat..great detail..

[ap40rocktruck]

Well done Alian!

so much better after lots of re-work.

Ap40

[PappyD340]

Simply AMAZING Alain!

[mackd]

Fantastical!

How did you bend the square tubing?

Hi James .There are three methods that I know of at the of a candle the results are more or less good.Thou the soak in very hot water good results.For this faith I have done the curves on the ledge in front of the table.Used thou full tube.

Alain

Edited August 19, 2013 by mackd

[Pat Minarick]

Very nice work !

[ewaskew]

Man that's some nice scratch building.

This thing will look real good when your finished with it.

[Mr mopar]

Now that's how the kit should have been............................... vary nice work Alain.

[slusher]

Amazing work...