Jump to content


Member Since 14 Feb 2011
Offline Last Active Nov 14 2014 05:05 PM

Topics I've Started

Magneto coil

31 July 2014 - 02:37 PM

I'm working on a Funny Car chassis that I am going to put under a resin body and I have some questions about the engine. This kit has a twin magneto set up and I am replacing the kit part with aftermarket magnetos and they come with a coil and wire to run from the coil to the mags. My questions are  1. Where would be a good place to mount the coil? 2. Would a double mag set up use 2 coils (I guess)? 3. Would there be a wire running to the coils and if so from where? This is what happens when you decide to give a try at wiring things!

Air bubbles

31 July 2014 - 06:01 AM

I have some resin parts I am going to use on a build and I was wondering how to repair small air bubbles? They aren't very big so I was wondering if there is an easy way to fill and sand, or what is the recommended way to repair this small flaw? Thanks

Malco Gasser Mustang

01 July 2014 - 04:42 PM

Who makes a good match for the light blue on the Malco Gasser Mustang? I shot a little Grabber Blue but it's too dark. I want to do the base color and then the darker blue also around the wheel wells and other areas.

Resin casting

09 June 2014 - 12:00 PM

I need to cast a second set of cylinder heads in 1/25 scale, is this easy? Will one of the small resin casting sets from Hobby Lobby do the trick?

Glue Bomb

10 May 2014 - 04:07 PM

How do I strip old glue off parts? I got hold of a John Milner dragster and I want to unglue the frame rails and the motor parts. Can I soak it in easy-off or something else to do this? I'm not really worried about the chrome parts on the engine because I can redo them with Alclad paints but the frame rails are done rather poorly and so is the rest of the engine, blower mounted backwards etc. etc....................