Source for 1/8 and 3/32 (or metric equivalent) brass strip?

[PHPaul]

I KNOW this stuff is (or at least was...) available, I have a couple of each left in my stash.  I want to re-supply but I can't find anything narrower than 1/4 inch.

Silly me, I unpackaged it to store in a cubbyhole and don't have the part number.   Reasonably sure it's K+S, but maybe not.

Edited February 11, 2022 by PHPaul

[SfanGoch]

Order it direct from K+S.

[Casey]

Not sure where you are in Maine, but some larger Ace Hardware stores carry the K+S metals racks.

Also, here: http://www.hobbylinc.com/htm/k+s/k+s3407.htm?source=froogle

eBay, Amazon, maybe even Grainger....just Google the specific part numbers after you go through the catalog at the link Joe provided.

[PHPaul]

K+S doesn't list the specific sizes I need.  Also checked all the places mentioned.  All 1/4 inch wide and up.

[Ace-Garageguy]

5 minutes ago, PHPaul said:

K+S doesn't list the specific sizes I need.  Also checked all the places mentioned.  All 1/4 inch wide and up.

You can cut it from sheet stock if they have the thickness you need.

A Dremel with a cutoff wheel will do it nicely. Dress the cut edge, presto-change-o, there is is.

Kindof a PITA, but if you need something specific, there's always a way.   

[SfanGoch]

Model Expo 1/32 x 1/8 x 12" Brass Strip 10 pcs.

[NOBLNG]

1 hour ago, PHPaul said:

K+S doesn't list the specific sizes I need.  Also checked all the places mentioned.  All 1/4 inch wide and up.

What thickness are you after? If it’s thin enough, you may even be able to trim it with a good pair of scissors, or cut it off of a sheet.

[PHPaul]

8 hours ago, SfanGoch said:

Model Expo 1/32 x 1/8 x 12" Brass Strip 10 pcs.

Perfect!  Thank you.