Jump to content
Model Cars Magazine Forum

Recommended Posts

Posted

I don't remember where I saw this and it might have been here a long time ago, but thought I'd share anyway. This is a "Printed Circuit Board holder." It is excellent for holding a body to put decals on when when you really need an extra hand. Good for holding chassis too for assembly. Lots of adjustability and it rotates. They go for $10-$20 online.

IMG_0501.JPEG.e9687eaae35ff6a6beb7931b050be5c2.JPEG

  • Like 7
  • Thanks 1
Posted

The only problem I had with one of those was that it wasn't long enough for some bodies. I fabricated a longer beam to use between the uprights.

  • Like 1
  • Thanks 2
Posted
On 9/1/2025 at 3:18 PM, Matt Bacon said:

Me too:

boss-mustang-topdown.jpg

I made a couple of “grippers” with foam pads on T-section aluminium that fit into the PCB “jaws”…

Best,

M.

I also attached some foam to the jaws. 

  • Like 1
Posted
13 hours ago, 58 Impala said:

I just bought one on sale from Micro Mark. Where did you guys get the longer aluminum bar to extend the jig?

 

If you can’t find the proper size bar you could split it at the middle and extend it somehow.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...