Fixture for applying decals

[Quiet Eric]

I don't remember where I saw this and it might have been here a long time ago, but thought I'd share anyway. This is a "Printed Circuit Board holder." It is excellent for holding a body to put decals on when when you really need an extra hand. Good for holding chassis too for assembly. Lots of adjustability and it rotates. They go for $10-$20 online.

[Miatatom]

The only problem I had with one of those was that it wasn't long enough for some bodies. I fabricated a longer beam to use between the uprights.

[Matt Bacon]

Me too:

I made a couple of “grippers” with foam pads on T-section aluminium that fit into the PCB “jaws”…

Best,

M.

[NOBLNG]

Thanks!👍 I Just ordered one and will modify as necessary.😎

[Miatatom]

On 9/1/2025 at 3:18 PM, Matt Bacon said:

Me too:

I made a couple of “grippers” with foam pads on T-section aluminium that fit into the PCB “jaws”…

Best,

M.

I also attached some foam to the jaws. 

[mcs1056]

Do they make one big enough for a 1:1 '65 Galaxie?