Jump to content


Member Since 23 Mar 2013
Offline Last Active Nov 25 2014 01:50 PM

Topics I've Started

GM Futureliner.

18 November 2014 - 09:39 AM

I've done a search and haven't found much of anything here so I was wondering does anyone make a resin/aftermarket GM Futureliner ? 

Roughly, what temp does kit plastic warp at ?

25 September 2014 - 03:16 PM

I know it's too general of a question but I just need a rough idea of what temp your basic AMT/MPC/Revell etc kit plastic will start to warp and deform at. I found someone with a bunch of unopened kits they want to sell but they have been in a steel shed for a few years. The seller said they were covered in storage boxes and will not let anyone open the kits individualy to check ? I have'nt seen them yet to see the condition of the boxes so I thought I'de ask before I take the drive.

Anyone interested in making Munn's rootbeer Cutlass decals ?

21 September 2014 - 09:44 AM

Just wondering if anyone would be interested in making decals for the Munn's rootbeer F-85 used in the movie Hot Rod ? I do not have the skills or capabillities of making them myself. There's been lots of the Willy's models built but noone has done the F-85. Anyone else interested in these ? 

MPC The Super Judge funny car chassis.

14 September 2014 - 02:41 PM

What other kits shared this same MPC chassis ?

Question about Monogram 29 Ford pick up motor.

11 September 2014 - 03:35 PM

Is the motor in the Early Iron 29 Ford an Olds or a Cadillac ? I thought it said Olds on the box but heard it's actually a Cadillac. I'm more familiar with the 60-70's Olds motors. Not so much with the earlier ones.