Jump to content


mole53

Member Since 30 Apr 2012
Offline Last Active Yesterday, 05:17 PM
-----

Topics I've Started

Bending tubing

06 July 2014 - 02:48 AM

Is there a tutorial or could someone tell me how to bend small dia. tubing without kinking it?

AMT double dragster?

16 May 2014 - 04:30 AM

I am starting the AMT dbl dragster rail kit, single engine, and was wondering if there is a 1:1 equal for the frame. Any info will be helpful

Sweet 16

27 September 2013 - 08:18 PM

I don't know if this should go here or not. I haven't figured out what this is going in but when I do ya'll be the first to know. I started this topic in the q & a section about a week ago and just got around to posting some pics.

 

Attached File  IMG_0418.JPG   31.67KB   0 downloads

Attached File  IMG_0404.JPG   27.54KB   0 downloads

Attached File  IMG_0415.JPG   34.54KB   0 downloads

Attached File  IMG_0420.JPG   29.01KB   0 downloads

 

Please don't laugh too hard at my photography, the only camera I have is my iphone. Comments are always appreciated.


mythical hemi questions

20 September 2013 - 08:05 AM

I got a couple of questions concerning a what-if blown V16 hemi that I am tinkering with.

 

  1) I plan on using two distributors, would the firing order be the same for both distributors or would it

      depend on distributor location (see question 2)?

 

  2) Is it thoretically possible to mount one distributor on the right side of the block or should they both

      be mounted together on the left side?

 

  3) If I install nitros, are the injectors befor or after the blower?

 

Thanks in abvance for any info/opinions that you can give, I'll try to post some picks when I get far enough along.

 

T.T.F.N.