Jump to content
Model Cars Magazine Forum

landman

Members
 View Profile  See their activity

  • Posts

    7,921

  • Joined

  • Last visited

 Content Type 

Everything posted by landman

  1. landman
    ?
  2. landman
    Added the door. I know, can't see it because it is rolled up inside its barrel. ?
  3. landman
    Gave it a gray rubbery coating on the roof.
  4. landman
    Niiiiiiiiiiiiiiiice!
  5. landman
    ?
  6. landman
    Niiiiiice!
  7. landman
    Thanks guys. Next is to figure out a roll-in roll-out dolly that fits on a fork lift, gets deposited at the rear of the trailer and pushed in by hand.
  8. landman
    Never even thought of that.As far as the plug wires go, iused a 3D printed distributor with a hollow in the center. I bunched the wires and glued them in there then I threaded them though the two little tubes. I use clear .5mm rubber cord and paint them. Glad you like it.
  9. landman
    Sorry, checked it, writing is too small.
  10. landman
    Mitsubishi 4G63t. DOHC,16v, L4. 2L/144hp.
  11. landman
    It is a big book. I’ll put on my reading glasses and maybe I can tell.
  12. landman
    Looks like the rod will succeed in keeping the roof/box straight.
  13. landman
    I thought about epoxy. I glued an aluminum rod in the inner outside curve of the roof to see if it will hold it straight. we'll see.
  14. landman
    I think the only other one I have seen is the Audi R8. And of course a few industrial engines.
  15. landman
    Glad you like it.
  16. landman
    Dodge V10. OHV V10, 488 cu.in./300 hp.
  17. landman
    And it runs.
  18. landman
    The guys have monted a Dodge V10 to the dyno trolley in preparation for a dyno run.
  19. landman
    When I attempted to glue the end hinges one came off the roof, the corner of the box came apart so I retired the project for the time being until the urge to fling it against the wall passes.
  20. landman
    The hinges displace the panel downwards so I had to trim the edge. Now the lines won't match. I had to use the heavy equipment to clamp the hinges to the side panel.
  21. landman
    That is something the 3D printers should do, at least the intakes.
  22. landman
    I saw one on the internet in a newer Chrysler. Kit was $179.00. I don’t think so. Will keep looking.
  23. landman
    thanks. Now i have to go hunting.?
  24. landman
    The trailer itself is done save for the fenders which need another coat of paint. Glued the panel hinges ro the roof. The white bar is to keep the roof straight while the glue dries. It has a bow to it. Clear plastic isn't malleable like styrene so I did not dare bend it backwards.
  25. landman
    Thanks Carl. It is from the AMT Shelby Charger kit.
×
×
  • Create New...