Len Woodruff

Thanks. I just ordered 2 tonight.

What retailer have them?

Funny Car Decals for Miller Warrior Monogram.

I listed a decal on eBay and mistakenly didn't reset the satrting price. Before I could change it someone bid on it at the .99 starting price. I would have set the starting price at $7.50 Should I cancel the bid (I am not sure how) or delete & relist? I am tempted to let it ride just to see what happens. Thx in advance for your comments.

Anybdy get a ship date on the C8 Vette?. It looks like it's ready to ship for both versions.

The C8 Z06 is a whole new engine with double overhead cams and normally asperated. No supercharger needed. The ZR1 will have twin turbos on the Z06 engine.

Thanks for the link. I fond one that might be usable.

I am not familiar with that tape.

Thanks Steve. Some of those could work.

Thanks for the hints. My wife found these grid sheets on-line to add to your ideas. On-Line grid sheets.

I know we used to shrink the grid paper to make trunk mats. Is it available already done? Thanks in advance for your help.

The C8 Corvette should be pretty close to being released.

Thanks for posting

I the tape tomorrow. I was also wondering about silicone sealer?

Thanks. I was just worried how to keep it from "floating" when I poured the new rubber over it?

Here is an update. I made the side cove dam using clay. I poured silicone rubber into the dam. I now have this piece that I need to make a female mold from the male mold from this piece of silicone. Any suggestions for how to do this? Can I glue this down using silicone glue? If I can find something to hold it in place then I can use mold release to keep it from sticking?

I would think they would do the C8.GT3 since it racing in the WEC which races in europe & asia.

Wow. Thanks for the info. I didn't know about it. That would work great for 1 sided casting.

Thanks. I am just surprised I can't find any on the hobby sites so you can pre-order? But if Revell hasn't released any info then they won't have it either.

That sounds like a perfect solution. I will give it a try in a couple of days and report back.

Thanks. We have about a dozen in our Corvette club including a Z06

Thanks. Any suggestions for holding the dam on the side of the body?

I am not able to find any release dates on this kit. They showed both tthee Hardtop and Convertible at NNL east so I would thing it would be close to release.

I need to make a mold of the side vents on a rare 66 Corvette. I don't want to cutup the body to do it. Can I build a dam around the vents or something like that to make the mold. Any help and pictures would be great. Thanks in advance for your help.

Looks like there will be 2 C8 Corvettes. Hardtop & Convertible. I am ready for these. Bring them!