I would like to chime in again about BMF. Today I spent 2 1/2 hours foiling my Trumeter Falcon kit. Now since I am kind of cheap with the BMF I normally trim it before I apply it trying to use only as much as I need to do whatever part or area I am foiling. After laying down the first piece and burnishing it down I went to trimming. Very tough to "pick" up the end to peel back the excess. I was able finally using a toothpick to get it off without doing any damage to the paint. For my next section ( I was doing the side trim ) I cut a piece that overlapped by a fair amount. I pressed it down lighty into place and then trimmed it. I had more excess material to grab and it came off pretty clean. I then burnished it down better. So for me, if I don't be so stingy when applying the BMF to begin with I seem to have better luck.