Hard_2_Handle_454 Posted July 16, 2020 Posted July 16, 2020 Been waiting on this to come out for awhile. I had nothing to say but good things about the model, to start. However, when it came time to put the chassis on, there came a fit issue. It was a struggle to get it in right and the front never did line up quite right. There's a bit of a gap. I also found out that the hood is too short! It needs to be just a little bit longer to fit correctly. So I had to push it forward a bit and leave a small gap. However, it doesn't line up with the lines of the car either. You can see that in the pics. SAM_0065 by Eric Lucas, on Flickr SAM_0066 by Eric Lucas, on Flickr SAM_0067 by Eric Lucas, on Flickr SAM_0068 by Eric Lucas, on Flickr SAM_0069 by Eric Lucas, on Flickr
Tom Geiger Posted July 18, 2020 Posted July 18, 2020 Round 2 must’ve known there is a hood fit issue. There’s a note on the instructions to sand on the radiator cross member to lower it
Hard_2_Handle_454 Posted July 18, 2020 Author Posted July 18, 2020 2 hours ago, Tom Geiger said: Round 2 must’ve known there is a hood fit issue. There’s a note on the instructions to sand on the radiator cross member to lower it Yeah, it's raised too.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now