1955 Ford Panel Truck

[Zippi]

This is the Revell Harley-Davidson '55 Ford Panel Truck.  I got this one finished yesterday.  Suspension has been modified to get the low stance.  I printed out the wheels & tires and kept scaling them up until I got the size the filled up the wheel wells and looked right.  I used the kit engine but replaced the 3 deuce setup with a 3D printed one I had on hand.  The Accel Coil and the master cylinder I printed out as well.  The inner portion of the wheels were painted with Tamiya Titanium Silver and the outer ring was painted with Rust-Oleum Chrome Metallic Finish as was the rest of the chrome on the truck.  I bmf the front, rear, and wing window trim. 

WIP:  https://www.modelcarsmag.com/forums/topic/202788-1955-ford-panel-truck/ 

 

Edited 13 hours ago by Zippi

[gray07]

Awesome build, love these panels

[TransAmMike]

Looks perfect there Buddy, great job on all of it 👍👍

[Zippi]

6 hours ago, gray07 said:

Awesome build, love these panels

Thanks man.

[Zippi]

11 minutes ago, TransAmMike said:

Looks perfect there Buddy, great job on all of it 👍👍

Thanks Buddy.  I appreciate it.

[speedboy57]

Great Build Zippy!

[BKF]

Nice job! Paint, engine, trim, stance wheels and tires all look great.

[ybsluos]

Bob, the stance and engine and wheels……all spot on!  I could easily see this in 1:1 at SEMA.  -Mark