MikeMc

Roger those are jaw droppers!!!!!Nicely done

Heres my latest set.....still need to polish them up and make a flange. Another....

Found an easy way to slip those plug boots onto the wires.....use a "T" pin, insert the boot 1/2 way onto the pin, line up the ig wire and slide it on with tweezers!

I thought it was longer than that...... this is what I use

Look out for SNOW!!!!

Well it is cold out and Harry needs warm toeseys.......But I can't WAIT!!!!!!! HIT US HARRY!!!!!!!!

OOOOHHHHHHHHH I Likey!!!!!! Chris..don't know if you have chopped one of these before...if not pay close attention to your front window frame and the inner A pillars. you have a stiffener in there that will cause grief....unless ya know!!

A little spark for this one from Morgan Design!! Thanks Kris!!

I couldn't of said it better!!!!!! and Thanks!!

I don't think so....the trunk DB9 badge is different

I got this one Erik, Couple of sources...look in the first sets of pix...yellow and blue box is a revell parts pack....found on evil bay I used the one from last years reissue done by stevens/ AMT #38677

Thats quite a tall statement...seeing as how it is a first...only safe way to race is not to race...I'd rather die at a race than on the bathroom floor!

Rusted manifold using Dr Crankys ideas...start with red oxide primer, spray and let dry. mist another light coat on and immediately sprinkle some kosher salt on, and let dry. Now spray a light coat of black, exhaust, burnt metal or iron and let dry. Now rub off the salt and see your pock marked manifolds appear. Practice until you get your needed look and then show us!

Nice tripod!

George, Danno, Harry?????????????

Well not a lot of progress this month due to personal things. Did finish the interior section, got the grill direction and a host of small details...

Walt, that is the 41 Willys street rod kit wheels, with a shot of dullkote on them.

Welcome and good to see you here Alex!!! Nice ride

I'm loving this ...the motor though is what really is unique. I noticed your source on this one is a parts pack. I'm using the same setup on my 32 sedan, but got the motor from the new Stevens reissue...its got a different setup than your using. Could you take a "top" shot so I can see your routing. What are you planning for the exhaust? Thanks Erik! This is where I'm going...

These are from Comp Resin get them HERE

XP with service pack 3 is all you need, as long as your browser is current!

The 41 street rod set is quite nice....

Mornin George....Is Harry up yet????????................HARRY!! Hit us now!!!!!!

Hope a huge motor is in the works....????

Verry kool and loud!!!! What I ended up with is a set of headers made from solder and tubing feeding into the stock pipes and packs I did not have a large choice as the exhaust had to tuck up between the rails due to its low clearance these will show you. (not trying to hijack this!!)