The door panels should slide right into place on the supplied notches. I may tack glue the dash to both door panels and see if I can slide that into the body as one unit.
I got a little bench time in this morning and got the suspension in a good place I hope. The rear axle housing is now up touching the chassis. Can't go any further. I cut the center section out of the leaf spring on the front axle and have it where I want it.
Thanks Carl. I don't think so. There is no interior tub to speak off. The floor pan glues strainght to the chassis and the two door panels just slide right into place.
I glued the top on the body as the trial fitting show that I can still get the back glass in. The joints don't looks to bad and I decided to delete the insert on the top. More of a clean look for a Street rod.
I think your right on the looks vs the AMT kit Richard. Yup, lots of options here so I think I'll set down and take a close look at the instructons again then make a decision on how to proceed.