MikeMc

Chilly we need facts....and you would be the source.....

SOON ????????????????

Mornin all.....as George says...."Hit me Harry"

Well I bought 2 and hafta admit it is one sweet kit!!!!

MARK! Calm down breathe in .......out....in.....out.......there that will be better. You are 100% correct but cut Jimi some slack ...He is a newbie....so he will learn! Jimi...listen to Mark and reread the prev post... I also might mention looking into resin bodys...more work and $$$ but more choices also!! BTW Welcome to our nuthouse....we do not bite!!!

assuming your using acrylics and not TS decanted, mix tamiya thinner between 1:1 and 2:1 (thinner : paint) and it will be like 2% milk in a glass..20 to 30 psi and go for it!

didn't ya call Harry P in the windy??? I'm sure he woulda taken good care of ya

Yepppp!!!! I chuckle as my son who is 25 moved back into my house, his old room (was my hobbie room) and now I'm stuck in the closet!!! and NO I'm NOT coming out

Since all I got left is change.....that must be where all of my $$$ went!!

Orkin doesn't do computer bugs..........

Many times I see a posting that is just bad. Rather than point it out I stay quiet. I'm not gonna say Great Paint....when its not. I look at the number of views and if nothing gets said..... I got the message. And then I learn...If I rip someones job...I'm not gonna start lying about it!!

Mornin Les....I think those midwesterners are still sacked out....Clay should be up.......

HOK sunrise pearl

As far as primer goes I reccomend Plasticote or Tamiya in rattlecans (decanted for your brush) with KK being a hybrid paint I would use future as a clearcoat.you can brush!! it or spray it and if your not happy...windex it off PS Ranger whats your name???

Goodnight Walter.......Godspeed and may the wind always be in your face......

The front glass has a rubber and chrome trim......I thought this was kool!!

Mornin Clay...if you wake up George He will wake Harry up!!!

I know that FE..but for it to run...yur gonna need 8 wires plus the coil

Thanks Bob You are 100% correct about seats! I feel better about my frustrations now after reading all of these replys, from my peers whose abilities are well respected in our hobby. I was looking at a resin BB chevy oil pan as I was filing this kit motor it was soooooo nice and smooth I also remembered the two hours I spent squaring up that block and heads ...so maybe this isn't all that bad Bob I do not quite get the CA and accelerator trick... I end up with a hard mess..and end up with putty and sanding Thanks again guys!!

well after reading this...I AM NOT ALONE!!! still frustrated though!!

Those pesky seams on motors. I wish I could figgure out how to get them flat! Valleys and oil pans. the bottom always shows that darn seam...I can hide it tranny thru bell housing but the oil pan and front pulley are awful In all my years of building I've ignored it but I can't anymore!! Do I file , scrape , sand , or fill.....or all of the above??? I'm doing the Baldwin camaro and that 427 pan looks awful bad..... and when the manifold went on....its high in the center....is it just me?? Tim Boyds don't look this bad...

MCM issue #138 jan 2009 Re read this and see all the power options!!

I think that says it all!!!!! WOW

No problem bud...but I sent you a V8...where did the other cylinders go?? And for the headers get a roll of armature wire or solder...simple to do!!

I did one of those...it was a paint test!!