I only have an hour every morning to work on this so this is another small update .
To fill the sink mark on the trunk I used Evercoat Polyester Putty . People complain that it goes bad to quickly but I've been using it since the early 80's and have never had any problems with it . If you mix the contents of the can thoroughly every time you use it , and keep the lid clean so it will seal properly , it will last for several years . Eventually after many years it will be unusable but I've had this can going on five years and it's still good !
Last night after sanding the area with 400 grit I taped off a small area to spray with primer . This morning I taped a slightly smaller area for the putty . Never try to mix a tiny amount , it will never work ! You need to mix about a spoonful with a dab of hardener to get it right .
It's ready to sand in about 15 minutes . I sand it to shape with 220 grit using a craft stick as a sanding block , then finish it with some 400 grit .
I need to check the entire body again for anything that needs fixing then tomorrow I can prime it and hopefully get some color on it Sunday .