NOBLNG

I just about didn’t click on this, but I’m glad I did.? It’s something a little different and it is very nicely done! I do like the stance on that. ?

Really nice looking wagon there John!?

That is one sweet looking Mustang!?Very well done!?

Dang, there sure are some fine looking rigs coming along in this thread! You fellas sure are a talented lot!?

That looks really great Jeff!?

That looks really nice Dennis! I have had good luck with all Mr.Hobby products. That clear is nice stuff, but can’t be used over decals they say.

And they are closer than these AMT ‘69 442 rims with the chrome rings.

Not too much progress. I did manage to get the engine and trans mounting locations finalized and the exhaust manifolds on. That allowed me to bend up some exhaust pipes from .100” evergreen and fab up a set of mufflers.? It’s pretty tight on the side where the front driveshaft goes, but I think I have a straight shot at it now.? I did give it a 1” body lift just to help clearances a bit.

That is a real beauty!?

Well done there Alan!? That is one of my all time favourite movies.?

AMT Blazer I’m working on.

Those were nice looking cars! I like what you plan to do with it.? I built a Revell 1960 Corvette with a multiple piece body and reinforced the seams on the inside with half round styrene and Testors glue.

Great start Jason! What brand of paint is that. Spray bomb or airbrushed?

X2…they are extremely sharp and extremely brittle.?

I got my MX-5 out of storage today. This is it parked beside the Assiniboine river which is nearly overflowing. I also saw a real nice gold ‘71(?) Lemans Sport convertible parked there. I went around again to get a pic, but it was gone.

The spare tires are a LOT bigger than what’s on there. Could this be some sort of support vehicle?

Very nicely done!? It’s a shame that some builds get buried for various reasons without the deserved amount of recognition.

Super nice build and a nice write up on the nuances of it too!?

Sharp looking’Cuda!?

That looks really good in all white Bob! Nice job.?

That sits real nicely on those wheels.?

Let us know how it works….I personally have not seen it.?

Dang that thing is minimal! ? Interested to see what you can do with it.??

You would want to remove the “foose” lettering. Cut “FORD” letters out of some .010” or .015” styrene and glue them on. If it doesn’t work out then swap the tailgates or entire box.

The very last bit of snow will be melting off my front lawn today!?